Insulating glass, as a building energy-saving material, is widely used due to its excellent heat insulation and sound insulation performance. Meanwhile, the quality requirements for insulating glass are getting higher and higher. It is understood that the biggest quality problem of insulating glass is the condensation of the air layer during use, and the reason for the condensation of the air layer is that the dew point of the air layer rises during use. Therefore, controlling the dew point of insulating glass is the key to controlling the quality of insulating glass.
During the use of insulating glass, when the ambient temperature drops to a level that reduces the surface temperature of the glass to the dew point within the dry air layer, condensation or frosting will occur on the surface of the dry air layer. The performance of insulating glass is affected due to condensation or frost on the inner surface of the glass. If it is ensured that the air layer does not condense at temperatures above minus 40 degrees Celsius, there will be no condensation in the air layer during the use of insulating glass.
The dew point of insulating glass refers to the temperature at which the humidity of the air sealed in the air layer reaches saturation. Below this temperature, the water vapor in the air layer will condense into liquid water. It can be deduced that the higher the water content, the higher the dew point temperature of the air. When the temperature of the inner surface of the glass is lower than the dew point of the air in the air layer, the moisture in the air will condense or frost on the inner surface of the glass.
The increase in dew point of insulating glass is caused by the moisture from the outside entering the air layer without being absorbed by the desiccant. There are three possible reasons that may lead to the increase in dew point:
(1) There are air bubbles in the sealant, allowing air and moisture to enter.
(2) Water vapor diffuses into the air layer through the polymer.
(3) The effective adsorption capacity of the desiccant is low.
