Insulated Glass Key Points Of Design

May 14, 2025

Leave a message

The butyl rubber used for the first seal of the 1-slot aluminum double-sealed insulating glass has an extremely low water vapor transmission rate. The second sealant mainly consists of polysulfide sealant and silicone sealant. The water vapor transmission rate of polysulfide sealant is lower than that of silicone sealant, but its UV resistance is not as good as that of silicone sealant. Therefore, it is suitable for Windows or framed glass curtain walls (as the aluminum frame can provide shade and prevent direct sunlight). Silicone sealant is suitable for hidden-frame glass curtain walls, and its UV resistance and strength are both higher than those of polysulfide sealant. When buildings have high decorative requirements for insulating glass, milky white or transparent silicone sealant can be selected. Silicone sealant should not be used as the second seal for wooden Windows because it has poor resistance to wood preservatives and the sealant may be damaged due to migration.

For the 2-interval aluminum frame, it is advisable to adopt the continuous long tube curved corner type, and the joint should be sealed with butyl rubber. If the aluminum frame with intervals adopts the four-corner plug-in type, each joint should also be sealed with butyl rubber. The service life of the insulating glass made in this way is not as long as that of the former. When silicone sealant is used as the second sealant for insulating glass, insulating glass with four-corner interlocking aluminum frames should not be used.

Because it is sealed with sealant, it should not be used at 70℃ or higher temperatures, otherwise it will greatly affect the service life of insulating glass.

The change in the internal pressure of the air layer in insulating glass causes the glass to deform, which can lead to image distortion. Therefore, when using insulating glass at an altitude of 1000m or above, the air pressure in the air layer must be adjusted. When placing an order, it should be discussed with the glass supplier.

The heat insulation performance of Windows is closely related to the material of the window frame, so window frame materials with good heat insulation performance should be selected.

If used as a skylight, the indoor side glass should be laminated or explosion-proof film.

7 Low-E insulating glass, with the film surface located on the second or third side, should be selected according to the design requirements. If the designed insulating glass must be in the form of large and small pieces, the film surface must be placed on the third side.

The maximum allowable area of the four-sided supported insulating glass is 1.5 times the maximum allowable area of the insulating glass calculated based on the thickness of two single glass sheets.

When designing buildings, the following technical performance requirements should be put forward: thermal insulation performance, heat insulation performance, sound insulation performance, lighting performance, sealing performance and weather resistance performance.

Send Inquiry
Contact us if have any question

You can either contact us via phone, email or online form below. Our specialist will contact you back shortly.

Contact now!