Yes, for the vast majority of glass processing steps, SGP intermediate film is indeed easier to handle and process than the traditional PVB intermediate film.
Core comparison: The differences between SGP and PVB in the processing stage

Character: The differences between SGP and PVB in the processing stage
PVB intermediate film: Soft and glutinous, lacking self-support, The edges tend to shrink and curl after cutting, so great care is needed when laying them, It has a high initial adhesion and adheres to the glass by means of temperature and pressure, A relatively long vacuuming time is required to expel the air within the laminate, It is highly sensitive to temperature and humidity, and the processing environment must be strictly controlled in terms of temperature and humidity (usually 23±2°C, humidity 25±5%), The autoclave cycle requires a standard high-temperature and high-pressure cycle.
SGP interlayer film: It is very tough and self-supporting, The edges are smooth after cutting, hardly shrink and are easy to lay,It has low initial tackiness and is almost non-sticky at room temperature,The required degassing time is significantly shorter, It has low sensitivity and lenient requirements for the environment, The autoclave cycle is similar to that of PVB, but due to its stable performance, the process window is wider.

Summary: Why is SGP easier to process?
From the above comparison, it can be seen that SGP interlayer film performs more "obedient" and "stable" in every pre-production stage - from storage, cutting, laying to pre-pressing and venting. It reduces the operational difficulty, lessens the reliance on harsh environmental conditions, enhances production efficiency and the yield of finished products, and is particularly suitable for processing glass with complex shapes, large sizes or extremely high quality requirements.
Important note: The application positioning of SGP and PVB is different
Although SGP is easier to process, the choice of material ultimately depends on the design requirements, not just the difficulty of processing.
PVB (Traditional and Economical)
Advantages: Lower cost, excellent sound insulation performance (especially acoustic-grade PVB), flexible, the glass will break when impacted but the fragments will be stuck and are less likely to fly (safety feature).
Main applications: Building doors and Windows, curtain walls, automotive windshields, and situations where safety is required but the load is not large.
SGP (High Performance)
Advantages: It has extremely excellent mechanical properties, with strength and shear modulus being 5 to 100 times that of PVB. It has good tear resistance. After the glass breaks, it can still maintain the overall frame structure and has extremely high residual load-bearing capacity and impact resistance.
Main applications
Structural glass: such as point glass, glass ribs, glass stairs, glass floors, etc., requires an intermediate film to bear structural loads.
Super-large panel glass and curtain walls with extremely high wind pressure resistance requirements.
Security field: such as explosion-proof glass, bank counter glass.
** overhead skylight **, because even if it breaks, the glass fragments will not fall in large areas, making it safer.
Conclusion
In the glass processing stage, SGP intermediate film is indeed easier, more stable and more user-friendly than PVB intermediate film, which can significantly reduce processing difficulty and improve production efficiency.
However, the final choice should be based on the specific requirements of the project:
If the project involves ordinary building doors, Windows or curtain walls and pursues economy and good sound insulation, PVB is a mature and reliable choice.
If the project involves structural glass, super-large glass, high safety level or complex geometric shapes, and the intermediate film needs to have ultra-high strength and stability, then even if the cost of SGP material is higher, its excellent processing performance and outstanding mechanical properties make it the best choice.
