How To Clean The Inside Of An Aquarium?

Aug 18, 2025

Leave a message

Cleaning the fish tank is an important step to keep the water clear and the fish healthy, but it is necessary to pay attention to the method to avoid disrupting the ecological balance or harming the fish population.

I. Preparations Before Cleaning

 

Tool list

 

Soft sponge/algae scraper (for cleaning the inner walls of glass)

 

Siphon (for water change and dirt removal)

 

Bucket (for storing old water)

 

A clean cloth (for wiping the exterior)

 

Water quality stabilizer (for adjusting water quality after water change)

decorative tempered glass01

Filter cotton (if to be replaced)

 

Safety Tips

 

Power-off: Turn off the heating rods, filters and other equipment to prevent electric leakage.

 

Retain some raw water: When changing water, keep 1/3 to 1/2 of the old water to avoid sudden changes in water quality.

Ii. Step-by-step cleaning process

1. Clean the inner wall of the glass

 

Algae treatment

 

Use a soft sponge or magnetic brush to gently remove the green algae on the cylinder wall. For stubborn areas, a scraper can be used (to avoid scratching the glass).

 

Note: Do not use chemical cleaners (such as dishwashing liquid), as residues can be toxic to fish.

display tempered glass01

2. Drain the bottom and change the water

 

Siphonic sewage discharge

 

Insert one end of the siphon into the bottom of the tank and align the other end with the bucket.

 

Press the suction head to start the siphon, which will suck away fish droppings, leftover feed and other debris at the bottom (pay special attention to cleaning the bottom sand and the crevices of the landscape).

 

Suggested water change rate: Once a week, 1/3 of the water volume (fresh water tank) each time. The seawater tank can reduce the frequency.

 

3. Clean the filter material

 

Filter cotton cleaning

 

Gently rinse the filter cotton with the extracted raw water to prevent the chlorine in tap water from killing the nitrifying bacteria.

 

Note: Replace the filter materials in batches to avoid system crash caused by replacing all at once.

 

4. Decorations and base sand

 

Stones/sunk wood: After removal, scrub with old water. Stubborn algae can be briefly soaked in white vinegar (thorough rinsing is required).

 

Bottom sand: Use a sand washer (bottom sand cleaner) to pump water while turning to remove the sediment.

 

5. Replenish fresh water

 

Fresh water should be left to stand for 1-2 days in advance to remove chlorine or water quality stabilizers should be added.

 

Pour it slowly into the fish tank to avoid the water flow hitting the fish body and the bottom sand.

III. Precautions

 

Do not over-clean

 

Retain some beneficial nitrifying bacteria (such as the biofilm on the filter material) and avoid cleaning the entire tank.

 

Consistent water temperature

 

The temperature difference between the fresh water and the original water in the fish tank should be no more than 2℃ to prevent the fish from being stressed.

 

Observe the state of the fish

 

If the fish float to the surface or become sluggish after cleaning, it might be due to fluctuations in water quality. Oxygenation should be provided and the fish should be stopped feeding for one day.

 

Send Inquiry
Contact us if have any question

You can either contact us via phone, email or online form below. Our specialist will contact you back shortly.

Contact now!